Aluminium Spacer for Hydraulic Press - 2 Sizes
From $28.17
In stock
Aluminium Spacer for Hydraulic Press - 2 Sizes
It's good practice to operate your press with the minimum amount of ram extension and these aluminium spacers are designed to sit underneath your work...
In stock
From $28.17
Clamp Stand for Hydraulic Crimping Tool
$10.56
In stock
Clamp Stand for Hydraulic Crimping Tool
This clamp acts as a table top stand for the YQK-70 hydraulic crimping tool. Once attached, the crimping tool can lay flat on a work surface allowing ...
In stock
$10.56
Flat Hardened Pusher for Shot Plates & Impression Dies
$42.25
In stock
Flat Hardened Pusher for Shot Plates & Impression Dies
The flat faced pusher is manufactured from hardened tool steel and attaches to the universal magnetic holder (not included) which in turn attaches to ...
In stock
$42.25
Hardened Anvil for Hydraulic Crimping Tool
$25.35
In stock
Hardened Anvil for Hydraulic Crimping Tool
This anvil replaces the crimping dies that come supplied with the generic YQK-70 hydraulic crimping tool. You need this anvil to create impressions wh...
In stock
$25.35
Magnetic Shot Plate Block
$126.76
In stock
Magnetic Shot Plate Block
Magnetic stainless steel block for use with impression dies and shot plates. This block adds mass and acts as a solid base when using a hammer and pun...
In stock
$126.76
Round Urethane
From $7.61
In stock
Round Urethane
UK manufactured round polyurethane pieces for use with a hydraulic press. Round urethane is available in two different hardness ratings - 90 Shore A (...
In stock
From $7.61
Small Urethane Pieces
$9.30
In stock
Small Urethane Pieces
UK manufactured polyurethane pieces for use with a hydraulic press. Each bag contains approximately 50 cubes (5mm thickness, roughly 1cm x 1cm) availa...
In stock
$9.30
Steel Jewellery Press Spacer
From $25.35
In stock
Steel Jewellery Press Spacer
It's good practice to operate your press with the minimum amount of ram extension and these steel spacers are designed to sit underneath your work the...
In stock
From $25.35
Tapered Hardened Pusher for Shot Plates & Impression Dies
This tapered pusher is manufactured from hardened tool steel and attaches to the universal magnetic base (not included) which in turn attaches to your...
In stock
$42.25
Universal Magnetic Base for the Hardened Pushers
$50.70
In stock
Universal Magnetic Base for the Hardened Pushers
This magnetic base is designed to attach to your press ram or top frame. It is fitted with two recessed magnets (top and bottom) and it can attach to ...
In stock
$50.70
Urethane Sheet
$9.30
In stock
Urethane Sheet
UK manufactured polyurethane pieces for use with a hydraulic press. 5mm thick sheet (100mmx100mm) available in Red 90 Shore A hardness and Black 60 Sh...
In stock
$9.30
